Mack Metro-Liner

Mack Metro Liner Mack Metro Liner

This ad has been sold. Please view similar ads below or start a new search by clicking buy.


Request a Quote

Request a no obligation, free quote on this product from your choice of dealers.

  • GVM: (6x4) up to 26,000kg
    (8x4) up to 30,000kg
    (10x4) up to 33,000kg†
    Wheelbase calculated using 1320mm Bogie Spread
    Maximum fuel capacity is VSS selectable combinations with batteries mounted on chassis. Turning circle measure to be used as a guide only, refer to WIS. Subject to application.
    Horsepower: (Hp): 320, 340, 360, 400
    Torque: (lb–ft) 996, 1100, 1180, 1255
  • Engine: Cummins ISL 8.9 litre, Selective Catalytic Reduction (SCR), Emission Level Euro5 (ADR80/03)
    Fan: Horton on/off fan clutch with 11-blade nylon fan
    Radiator: NL3, Frontal area 1,435in²
    Exhaust: RHS vertical, post-mounted exhaust catalyst with chrome 5” (127mm) outlet, Exhaust tip height above
    ground 3,400mm
    Air Intake & Filter: Donaldson 279mm (11”) Single dry type element, Under bonnet air intake
    Filters: Oil & Fuel: Single spin-on disposable filter, Fuel: Fleetguard water separator chassis mounted, Water: Single spin-on disposable
    Air Compressor: Single CYL. 530 litres/min (18.7 cfm) WABCO compressor
  • Transmission: Manual, Automated Manual and Automatic transmissions
    (Refer Transmission Chart)
    Retarder optional (340Hp only) (CA)
    Transmission oil cooler
    PTO Provision: Chelsea 870 PTO (Auto only), Prep kit, switch and wiring only (optional)
  • Front Axle: Mack FXL with unitised hubs (Refer Steer Axle Chart), Axle position: Mid Axle Fwd 1008mm
    Steer Axle: Mack FXL 14.6 14,600lbs (6.6t) (P3) Standard axle
    Mack (Aus) Twin FXL 14.6 29,200lbs (13t) (P3) Load share mechanical
    Meritor FG941 14,600lbs (6.6t) (P3,M7) Disc brakes (CA)
    * Parabolic Standard Duty (P) – Number = Leaf Qty
  • Rear Axles: Meritor and Dana axle options (Refer Drive Axle Chart), Ratings 18 to 21 tonne
    Drive Axle: Meritor RT40-145 40,000lbs (18t) 4.63, 5.29, 6.14, 6.43, 6.83 MaxLite 40/AL460/MIL-M/HN402 (CA)
    Meritor RT46-160 46,000lbs (21t) 4.89, 6.14, 6.43 HN462
    Dana DSH40P 40,000lbs (18t) 4.88, 5.29, 6.17 HN402
    Hendrickson HLM2 Liftable lazy axle CSM 10x4 AL460
  • Inter-axle/Wheel Locks: DCDL one axle only (vendor axles only), DCDL’s on both axles (optional)
    Driveline: Spicer 10 Series
  • Front Suspension: 1,321mm (52") long Parabolic springs
  • Rear Suspension: Air and mechanical (Refer Drive Axle Chart), Ratings 18 to 21 tonne, Out board mounted shock absorbers, In-board mounted shock absorbers (AL460 only)
  • Brakes: Front and Rear automatic slack adjusters, Type 20 brake boosters, S’ Cam with iron drums, S’ Cam with centrifuse drums (optional), Type 24/30 brake boosters (standard on 8x4 & 10x4), Type 30/30 brake boosters (standard on 6x4), S’ Cam with cast iron drums, S’ Cam with centrifuse drums (optional), Low tare alloy hubs (optional), ABS or (optional) ABS with Traction Control, Road Stability Advantage (ESP - Electronic Stability Program)
    – optional
    Engine Break: C Brake by Jacobs, compression brake, Engine retarding power up to 185kW (250Hp)
  • Steering Gear: Sheppard M100P, Steering ratio 18.9:1
  • Wheels: 10-stud 8¼” (285mm PCD) steel disc, 10-stud options: 10-stud 8¼” (285mm PCD) machine buff / polished alloy / DURABRIGHT alloy discs 10-stud 9” (285mm PCD) polished alloy or DURABRIGHT alloy discs
    Tyres: Bridgestone / Michelin tyres
    Tyre Equipment: Wheel lug wrench kit, Bottle jack (optional)
  • Specs: 26” round polished alloy tanks (Refer Wheelbase Chart), AdBlue Tank, kerbside (LHS) location, 60 litre plastic (125 litre optional 6x4 only)
  • Chassis: Advantage 300mm x 90mm x 7mm, 138,000psi/RBM 1,730,000in lb
    Advantage 300mm x 90mm x 8mm, 156,000psi/RBM 1,940,000in lb
    Advantage 300mm x 90mm x 9.5mm, 184,000psi/RBM 2,240,000in lb
    Dependent on wheel base and rear axle
    Afterframe: 1,515mm (59.6”) to 2,810mm (110.6”) rear overhang
    All chassis lengths can be specified with tapered rail ends
    Cab Support: Front: Two metalistic pivot mounts
    Rear: Air isolation with dual shock absorbers
    Bullbar/ Bumper/ FUPS: Light weight alloy bumper
    Front Underrun Protection
  • Batteries: Two 12volt Bulldog batteries, high capacity (620 CCA), LHS with a black battery box cover, Polished aluminium battery box cover (optional)
    Alternator: Leece Neville 12volt/100Amp Brushless, Leece Neville 12volt/160Amp Brushless (optional 340Hp only)
    Starter: Delco Remy 38MT 12volt electric starter, Key type start and stop
    Electrical: Chassis harness with protective conduit
    Electrical prep kit, Body Builder chassis connections (optional)
    Courtesy Lamps: Drivers/Passengers door entry lighting, Ambient floor lighting
    Headlamps: Hella integral light/indicator unit with Polycarbonate lens
    Marker & Tail Lamps: 5 roof-mounted amber lights and 3 in 1 tail lamp
    LED roof clearance and tail lamps (optional)
    Reversing Alarm: Chassis mounted back up alarm (optional)
    Warning Beacon: Single amber revolving roof beacon (optional)
    Hook Up Lamp: Rear of cab mounted hook up lamp (optional)
  • Wheelbase: 4,724mm (186”) to 6,150mm (242”)
  • Air Dryer:
    Bendix AD-IS air dryer
    Remote Breathers:
    Transmission, fuel and axle remote breather kit (optional)
    Trailer Connections:
    Rigid to rear of frame (optional)
    Air: Service and emergency with blanking plugs
    Electrical: 12volt 7-pin female base with HD 5mm² cabling (optional)
    Mack telematics system - speak with your Authorised Dealer for further information.
    Fusion Cab, ECE29 (cab strength test) compliant
    Two piece windscreen
    Cab Interior:
    Overhead storage (based on cab configuration)
    Rear Wall storage available (based on cab configuration)
    Door Storage (2 pockets)
    Cup Holders in dash
    Centre storage console (available based on cab configuration)
    Interior Trim - pleated ultra leather or diamond plate
    Central locking available
    Power windows available
    Self cancelling signals
    Internal grab handles
    Speak with your Authorised Dealer for all options
    Driver: ISRI ‘Big-Boy’ air-ride: cloth trim, upper, side and lower lumbar support with fore/aft seat cushion adjustment
    Driver: ISRI ‘Big-Boy’ air-ride Premium (optional): ‘MACK’ embossed cloth trim, LH arm rest, upper, side and lower lumbar support with oscillating base and fore/aft seat cushion adjustment
    Passenger: ISRI fixed cushion
    Passenger: ISRI premium air ride seat with upper and lower lumbar support, and fore/aft seat cushion adjustment (optional)
    Steering Wheel:
    Bulldog soft touch rubber grip 457mm (18”) diameter, Adjustable tilt and telescopic steering column
    Driver information display: Co-Pilot
    Speedometer/odometer (electronic)
    Tachometer/hourmeter (electronic)
    Voltmeter, engine hours, distance, trip recording
    Engine coolant temperature, fuel and AdBlue levels
    Primary and secondary air pressure
    Oil pressure and oil temperature
    Full Gauge Package:
    Manifold pressure, transmission temperature, exhaust temperature, brake application pressure, front and rear drive axle temperature
    Windscreen Wipers:
    Electronic variable-speed, intermittent wipers with washer, Washer fluid reservoir mounted under bonnet
    Audio System:
    Base Radio/CD player, Premium Radio/CD player including hands free (optional), iPod connector and USB connector (optional)
    GME CB radio (optional), GME UHF radio (optional)
    Climate Control:
    HVAC integral cab air conditioner/heater, Electronic controls, Replaceable dust intrusion filter
    Safety & Warning:
    Set of 3 safety warning triangles, Door mounted emergency procedure guide (optional), Emergency eye wash bottle (optional), 2.5kg in cab mounted fire extinguisher (optional)
    Cab Exterior:
    Fibreglass bonnet and polyfibre fenders with splash aprons, Bonnet tilts forward with spring assist, Chrome grille surround and side air intakes (optional), Black nylon bonnet hold down straps, Bright finish bonnet hold down straps (optional), Stainless bug screen integrated with grille, Painted external sunvisor
    2 x roof mounted, air horn trumpets, 2 x under bonnet mounted, electric
    Heated ‘West Coast’ mirrors with stainless steel arms, LH and RH power mirrors (optional), LH and RH 7” spotter mirrors, LH down mirror (optional)
    Windscreen Stone Guard:
    Matt black mesh windscreen stone guard (optional)
    Paint Type & Colour:
    Cab/sleeper: Single non-metallic cab colour, (Incredible white standard), Chassis: Single non-metallic chassis colour (black standard), Epoxy Mine specification primer (CA)
    Many factory fitted accessories which are not listed, are also available, All customers are encouraged to see their Authorised Dealer for full details
    * Subject to conditions:
    Refer to your authorised Mack Dealer for:
    Detailed information
    Full Warranty details and limitations.
    Further details regarding the mass of options.
    The latest details on specifications, options, prices and availability

Request Quote

You might be interested in...