Request a no obligation, free quote on this product from your choice of dealers.
| Base Specifications: | GVW: up to 34 tonne GCM: 50 - 70 tonne, up to 110 tonne on application |
| Engine: | MP8 |
| Horsepower: | 435 or 500 |
| Torque: | 2250Nm (1659 ft. lb) or 2550Nm (1880 ft. lb), dependent on horsepower |
| Axle Configuration: | 6x4, 8x4, 10x4 |
| Engine: | Mack MP8 12.8 litre, Maxi-Cruise torque settings, Selective Catalytic Reduction (SCR), Emission Level Euro5 (ADR80/03) |
| Fan: | Behr Visco Drive (electric over viscous fan clutch), 750mm (29.5”) 9-blade nylon fan |
| Radiator: | NL3, Frontal area 1,435in² |
| Exhaust: | Single RHS frame mounted catalyst with stainless heat shield Outlet single RHS or twin 152mm (6”) vertical exhaust (Day Cab) Outlet single LHS 152mm (6”) vertical exhaust (Sleeper Cab) Outlet single 127mm (5”) underframe outlet (optional) Exhaust tip height above ground 3.5mtr (standard) 4.2mtr (optional) |
| Air Intake & Filter: | Donaldson 279mm (11”) Single dry type element, Under bonnet air intake |
| Filters: | 2 full flow and 1 bypass engine mounted oil filters, 2 step dual engine mounted fuel filters/water separator |
| Air Compressor: | 2 CYL. 900 litres/min WABCO compressor |
| Type: | Single Plate 430mm (17”) (mDRIVE), Eaton 394mm (15.5”) Easy Pedal with VCT Plus, Eaton ‘Solo’ with VCT Plus (optional), Air assist clutch release |
| Transmission: | Manual and Automated Manual transmissions, Transmission oil cooler |
| PTO Options: | Rear of engine PTO, Transmission mounted PTO (optional on mDRIVE), Prep kit, switch, wiring and software (mDRIVE) (optional) |
| Front Axles: | Mack FXL with unitised hubs (Refer Steer Axle Chart), Axle position: Axle Back 1,297mm Bumper to Front Axle |
| Rear Axles: | Mack, Meritor and Dana axle optionals (Refer Drive Axle Chart), Ratings 18 to 21 tonne (up to 24 CA) |
| Inter-Axle/Wheel Locks: | DCDL one axle only (vendor axles only), DCDL’s on both axles (optional on Mack and vendor), Mack Power Divider (standard with Mack axles) |
| Driveline: | Spicer 10 series, SPL Maintenance Free (option) |
| Front Suspension: | 1,321mm (52”) long springs (Refer Steer Axle Chart) |
| Rear Suspension: | Air and spring (optional) (Refer Drive Axle Chart), Ratings 18 to 21 tonne (up to 24 (CA), Out board mounted shock absorbers, In-board mounted shock absorbers (optional) |
| Breaks: | Front automatic slack adjusters, Type 20 front brake boosters, Type 24 brake boosters, S’ Cam with iron drums, S’ Cam with centrifuse drums (optional) Rear automatic slack adjusters, Type 24/30 brake boosters (8x4 only), Type 30/30 brake boosters (6x4 only), S’ Cam with cast iron drums, S’ Cam with centrifuse drums (optional) Low tare alloy hubs (optional), ABS or (optional) ABS with Traction Control, Grade Gripper - Hill Start Assist (with mDRIVE), Road Stability Advantage (ESP - Electronic Stability Program)– optional |
| Engine Break: | Advanced PowerLeash engine brake, Engine retarding power up to 315Kw (495hp) @ 2,100rpm |
| Steering Gear: | Sheppard M100P, Steering ratio 18.9:1 |
| Wheels: | 10-stud 8¼” (285mm PCD) steel disc, 10-stud options: 10-stud 8¼” (285mm PCD) machine buff / polished alloy / DURABRIGHT alloy discs, 10-stud 9” (285mm PCD) polished alloy or DURABRIGHT alloy discs |
| Tyres: | Bridgestone / Michelin tyres |
| Tyre Equipment: | Wheel lug wrench kit, Bottle jack (optional) |
| Specs: | 26” round polished alloy tanks (Refer Wheelbase Chart), AdBlue Tank (LHS) location, 60 litre plastic (8x4 only), 125 litre stainless steel 26” round, 150 litre stainless steel 26” round (optional) |
| Chassis: | Advantage 300mm x 90mm x 7mm†, 138,000psi/RBM 1,730,000in lb Advantage 300mm x 90mm x 8mm†, 156,000psi/RBM 1,940,000in lb Advantage 300mm x 90mm x 9.5mm†, 184,000psi/RBM 2,240,000in lb Advantage 300mm x 90mm x 11.1mm†, 212,000psi/RBM 2,590,000in lb Dependent on wheel base and axle capacity |
| Afterframe: | 1,365mm (53.7”) to 1,555mm (61.2”) rear overhang All chassis lengths can be specified with tapered rail ends |
| Cab Support: | Front: Two metalastic pivot mounts Rear: Air isolation with dual shock absorbers Rear panard rod |
| Bullbar/ Bumper/ FUPS: | Front Underrun Protection Light weight alloy bumper Polished alloy fold-down bullbar (optional) |
| Chassis Access Step: | Staired and perforated 2 step design (optional) |
| Batteries: | Four 12volt Bulldog batteries, high capacity (620 CCA), LH and RH frame mounted with black battery box cover, Polished aluminium battery box cover (optional), Batteries mounted in sleeper if fitted, Stacked battery box (CA) |
| Alternator: | Leece Neville 12volt/160Amp Brushed, Leece Neville 12volt/160Amp Brushless (optional), Leece Neville 12volt/185Amp Brushless (optional) |
| Starter: | Delco Remy 39MTHD 12volt electric starter Key type start and stop |
| Electrical: | Chassis harness with protective conduit |
| Courtesy Lamps: | Drivers/Passengers door entry lighting, Ambient floor lighting |
| Headlamps: | Hella integral light/indicator unit with polycarbonate lens |
| Marker & Tail Lamps: | 5 roof-mounted amber lights and 3 in 1 tail lamp LED roof clearance and tail lamps (optional) |
| Reversing Alarm: | Chassis mounted back up alarm (optional) |
| Warning Beacon: | Single amber revolving roof beacon (optional) Dual Revolving Beacon (optional) Beacons are fitted to the sleeper when a sleeper option is selected. |
| Hook Up Lamp: | Rear of cab mounted hook up lamp (optional) |
| Wheelbase: | 4,460mm (175.6”) to 5,250mm (206.6”) |
| Air Dryer: | |
| Bendix AD-IS air dryer | |
| Remote Breathers: | |
| Transmission, fuel and axle remote breather kit (optional) | |
| Trailer Connections: | |
| Trailer - connections back of cab Trailer - connections back of cab and rear of frame (optional) Air: Service and emergency blanking plugs Electrical: 12volt 7-pin female base HD with 5mm2 cabling |
|
| Telematics: | |
| Mack telematics system - speak with your Authorised Dealer for further information. |
|
| Shell: | |
| Fusion Cab, ECE29 (cab strength test) compliant, Two piece windscreen | |
| Cab Interior: | |
| Overhead storage (up to 3 pockets based on cab configuration), Rear Wall storage available (based on cab configuration), Door Storage (2 pockets), Cup Holders in dash, Centre storage console (available based on cab configuration), Interior Trim - pleated ultra leather or diamond plate, Central locking available, Power windows available, Self cancelling signals available, Internal grab handles, Speak with your Authorised Dealer for all options | |
| Seats: | |
| Driver: ISRI ‘Big-Boy’ air-ride Premium: ‘MACK’ embossed cloth trim, LH arm rest, upper, side and lower lumbar support with oscillating base and fore/aft seat cushion adjustment Driver: ISRI ‘Big-Boy’ air-ride (optional): cloth trim, upper, side and lower lumbar support with fore/aft seat cushion adjustment Passenger: ISRI fixed cushion Passenger: ISRI premium air ride seat with upper and lower lumbar support, and fore/aft seat cushion adjustment (optional) |
|
| Steering Wheel: | |
| Bulldog soft touch rubber grip 457mm (18”) diameter, Elite leather grip steering wheel (optional) Adjustable tilt and telescopic steering column |
|
| Driver information display:: | |
| Co-Pilot, Speedometer/odometer (electronic), Tachometer/hourmeter (electronic), Voltmeter, engine hours, distance, trip recording, Engine coolant temperature, fuel and AdBlue levels, Primary and secondary air pressure, Oil pressure and oil temperature | |
| Full Gauge Package: | |
| Manifold pressure, transmission temperature, exhaust temperature, brake application pressure, front and rear drive axle temperature | |
| Windscreen Wipers: | |
| Electronic variable-speed, intermittent wipers with washer, Reservoir mounted under bonnet'''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''''' | |
| Audio System: | |
| Premium Radio/CD player including hands free, iPod connector and USB connector | |
| Communications: | |
| GME CB radio (optional), GME UHF radio (optional) | |
| Climate Control: | |
| HVAC integral cab air conditioner/heater, Electronic controls, Replaceable dust intrusion filter | |
| Safety & Warning: | |
| Set of 3 safety warning triangles, Door mounted emergency procedure guide (optional), Emergency eye wash bottle (optional), 2.5kg in cab mounted fire extinguisher (optional) | |
| Cab Exterior: | |
| Fibreglass bonnet and polyfibre fenders with splash aprons, Bonnet tilts forward with spring assist, Chrome grille surround and side air intakes, Black nylon bonnet hold down straps, Bright finish bonnet hold down straps (optional), Stainless bug screen integrated with grille, Painted external sunvisor | |
| Mirrors: | |
| Heated ‘West Coast’ mirrors with stainless steel arms, LH and RH 7” spotter mirrors, LH and RH power mirrors (optional), LH down mirror (optional) | |
| Windscreen Stone Guard: | |
| Matt black mesh windscreen stone guard (optional) | |
| Paint Type & Colour: | |
| Cab/sleeper: Single non-metallic cab colour, (Incredible white standard), Chassis: Single non-metallic chassis colour (black standard), Epoxy Mine specification primer (CA) | |
| Accessories: | |
| Many factory fitted accessories which are not listed, are also available, All customers are encouraged to see their Authorised Dealer for full details | |
| * Subject to conditions: | |
| Refer to your authorised Mack Dealer for: Detailed information Full Warranty details and limitations. Further details regarding the mass of options. The latest details on specifications, options, prices and availability |
|
